North Coast Synthesis MSK010 Fixed Sine Bank

Out Of Stock

Click Image for Gallery

north coast synthesis msk010 fixed sine bank

please specify variant in 'order notes' or via email when ordering

Never run out of modulation sources again. With the MSK 010 you get eight fixed-frequency LFOs with nice smooth sine waveforms in 8HP, which is one of the best LFO to HP ratios in the Eurorack world.

The MSK 010's Wien-bridge oscillator cores produce low-frequency sine waves natively, in a fully analog way with a minimum of harmonic distortion. There are no glitches from waveshaping or stair-steps from insufficiently filtered digital-to-analog conversion. Modulate synthesis parameters with these for smoothly evolving timbres and mind-expanding soundscapes. Because the cores are fully independent and will not synchronize, a patch using multiple LFOs will not repeat its modulation state for a long time, if ever.

Choose one of three variants of this module, each with its own set of eight nominal frequencies and cycle times. There are no duplicate or near-duplicate frequencies between different variants, so with two or three, you get the full benefit of a larger modulation palette. Note that the nominal frequencies are just that; every module will have its own one-of-a-kind pattern of exact output frequencies within a few percent of the nominal values, due to component tolerances.

Variant A - 16mHz, 60mHz, 190mHz, 410mHz, 720mHz, 1.3Hz, 4.8Hz, 16Hz (63s cycle time down to 63ms)
Variant B - 34mHz, 88mHz, 160mHz, 280mHz, 600mHz, 1.8Hz, 3.4Hz, 11Hz (30s cycle time down to 94ms)
Variant C - 28mHz, 72mHz, 130mHz, 340mHz, 2.2Hz, 4.1Hz, 7.2Hz, 8.8Hz (35s cycle time down to 110ms)

The MSK 010 is available as a pre-built 8HP Eurorack module or for do-it-yourself construction, with prices as low as zero (if you download the plans and source all the parts yourself). Imagine having enough LFOs to modulate everything.

All-new design, not a clone or imitation of anything else
Fast starting - full amplitude oscillations within one cycle of power-up, unlike the usual behaviour of an oscillating filter
Through-hole design for easy hand construction and maintenance
Connectors between boards, and panel components, mounted on the boards; no flying wires
All three variants build from the same bill of materials; one full kit or PCB set can be used to build any one variant of your choice.
No compromises on component quality: real aluminum panel, not PCB material, with colour printing; nickel and gold plating on the circuit boards; close-tolerance fixed resistors and integration capacitors.
Complete technical documentation released under GPL

Specifications

8HP Eurorack synthesizer module, 43mm deep including mated power cable.
Maximum current requirements in normal use: 40mA +12V, 40mA -12V. Reverse-connection protected.
Build difficulty: easy. All through-hole. No adjustment or trimming.